[Healeys] Tank strap hardware

[Bob Haskell]

The large washer has a section cut off so it will clear the lip of the 
shroud/trunk floor.  Moss now sells them.

Bob Haskell
AHCA 3000 Mk I registrar
http://www.ciahc.org/registry_3000mk1.php

On 08/20/2012 06:20 PM, warthodson at aol.com wrote:
> The tank straps should have a "T" shaped bolt captured in the end of each
> strap. The bolt passes thru a hole in the boot floor. On the underside of the
> boot floor a large diameter washer is placed on the bolt then a nut. The nut
> is tightened to pull the strap done onto the fuel tank & hold it in place.
> Gary Hodson
>
>
> -----Original Message-----
> From: Stephen Hutchings <s.hutchings at rogers.com>
> To: Jack Feldman <healeys at autox.team.net>
> Sent: Mon, Aug 20, 2012 5:07 pm
> Subject: [Healeys] Tank strap hardware
>
>
> I've got the little brackets in the rear bulhead where the tank
> straps connect, but my car had nothing at the other end for
> attachment.
> Now that I'm putting it all together again, my question is; should
> there be a similar set of brackets at the trunk/boot floor end to
> hold the straps, or is there a different fitting attached to the
> floor?
>
> Thanks,
> Stephen, BJ8