[Healeys] 65BJ8 fuel lines.

[Greg]

George,

Yes, super clear. These are great.

Thanks for the help.

Greg

Sent from my iPad

On Aug 5, 2012, at 7:55 PM, George Haywood <haywoodone at hotmail.com> wrote:

> Hi Greg,
>
> Here are a couple of pictures of my 65 bj8 fuel pump/lines configuration.
They are like the original lines.  You can see the banjo fittings.  It is a
tight fit but carefully bend your lines so the mating surfaces line up then
tighten them and you're good to go.  It might help to bend the lines so they
mate with the banjos attached to the pump housing, then loosen the banjos a
few turns, fit the fuel lines to the banjos, and finally retighten the banjos
while keeping the fuel lines in position so as not to stress the mating
surfaces of the nipple/fuel line.  Hope that is clear.  When you tighten the
banjos you'll see what I mean as they rotate.
>
> Take care,
>
> George
> 65 bj8 (30020)
>
> > From: gmandas at yahoo.com
> > Subject: [Healeys] 65BJ8 fuel lines.
> >
> > All,
> > My 65 early phase II BJ8 (30260) fuel lines have banjos on the fuel pump
ends.
> > Is this correct?
>
> <Restoration '65 AH bj8 356.JPG>
> <Restoration '65 AH bj8 358.JPG>