[Healeys] Torrington roller bearings trunnion
Chris Dimmock
austin.healey at gmail.com
Sun Oct 16 00:31:57 MDT 2011
Hey Guys,
I have got a Torringtom roller bearing setup to replace the phosphor
bronze bushes in the top of the king pin to trunnion, that I'm going
to fit on my BJ8.
I'm guessing you fit them dry, with a hand full of shims, set a
minimal end float (around a thou or so) by adding and removing shims,
then once you have required end float dry, pull apart and repack with
grease and reassemble.
Is that correct??
Any grease grade/ type comments?? Clearance comments?
Hoping it will help low speed manouverability with lots of neg camber,
6in wheels and Penrite steering molasses in the steering box....
Best
Chris
www.myaustinhealey.com
PS Go Casey Stoner you legend - Winner of the 2011 Moto GP
championship today! And go the Wallabies tonight!!!
Sent from my iPhone
More information about the Healeys
mailing list