[Healeys] Insulation

Austin Healey pajtamuvek at gmail.com
Sun May 29 00:33:41 MDT 2011


I am in about the same situation. Engine, transmission in, new loom wiaiting
to be installed.

Gergo

2011/5/28 I Erbs <eyera3 at gmail.com>

> Would like to see some photos,
> I still need to bolt down my tranny mounts and drive shaft. New wire
> harness
> this weekend, carbs back in two weeks, then hook up and restart car for
> first time in 20 months, when we started this project.  Still lots to do,
> but a lot has been completed.
> Good luck with recovery. Do your exercises
>
> Ira Erbs
> DIGS-4 Solutions
> Portland, OR
>
> sent from my Droid, please excuse typos and random self corrections because
> my phone has It's own ideas about what word I meant to write
>
> On May 27, 2011 12:04 PM, "Thomas Morrione" <tjmorrio at colby.edu> wrote:
> > Ira b9 fwiw b9 I put my grommets in after I put on durmat and the
> tarpaper.
> It
> > worked ok in all but two of the cases where I didnB9t cut holes quite
> large
> > enough b9 suggest just eyeball it and see if thereB9s any likelihood that
> > youB9ll not be able to put the grommet in without more trimming. I did
> put
> > the couple of balk gromment/plugs in before I put on the duramat. Forgot
> > which those were though. Have just had knee replacement last week and am
> > laid up or would go look further.
> >
> > Have enjoyed your chronicle of rebuild b9 am about to put in redone
> > engine/trans/od this summer and move my project along/
> >
> > Best,
> > Tom
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/pajtamuvek@gmail.com


More information about the Healeys mailing list