[Healeys] First start

[Oudesluys]

After 25 years it might be a good idea to  dismantle, clean and 
lubricate the starter. Renew the brushes if neccesary and clean the 
collector on a lathe with some very fine emery paper. If groves are 
clearly present take a small fine cut from the collector and remove the 
insulating material between the segments with a ground flat hacksaw 
blade to about 0,5 mm below the surface if necessary.
Lubricate the bearings by soaking them in thin oil for about 24 hours or 
immerse them in hot thin oil and let cool down while in the oil. 
Lubricate the sliding surface of the spindle/gearwheel with a little 
graphite powder and rub in with a small bit of chamois leather.

Same with the starter solenoid and battery cut-off switch, dismantle, 
inspect, clean the large contacts points or renew the complete assembly.

Check the battery terminals for tightness and cleanliness.
Check the battery and engine earth straps for cracks and cleanliness of 
fixing points to engine/chassis.


After such a long time contacts tend to be corroded and are the cause of 
increased resistance hampering performance. Not only that, but they also 
form a fire hazard as they can get very hot.

Kees Oudesluijs
NL

[demime 1.01d removed an attachment of type text/x-vcard which had a name of coudesluijs.vcf]