[Healeys] Is this 100 head warped??

[Dave Porter]

.002in should be no problem for a gasket to overcome. Where did the gasket
fail? Was it where you notice the low spot? Which side, if you can tell,
head or deck?
dave

frogeye at porterscustom.com

Porter Customs   2909 Arno NE
Albuquerque, NM USA 87107
505-352-1378
1954 BN2  1959 AN5
Porter Custom Bicycles

cars:
 www.britishcarforum.com/portercustoms.html
gallery:
http://picasaweb.google.com/porterscustombicycles/PorterCustomBicyclesStuff

blog: http://porterbikes.com/


-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of T+ B Willig
Sent: Saturday, September 18, 2010 1:12 PM
To: healeys at autox.team.net
Subject: [Healeys] Is this 100 head warped??

Hello,

I was facing the typical problem of a blown head gasket since last week
(overheating, emulsified engine oil), so I decided to remove the new DW alu
head again. After cleaning the mating surface, I checked it with a
straightedge. Between the second and the third cylinder there is a small gap
under the straightedge were I can pass a 002 (0,05mm) feeler blade. Do you
think that I should send the head away for surface grinding, or is this
within tolerances?

Regards


Thomas Willig
_______________________________________________
Healeys at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/frogeye@porterscustom.com