[Healeys] FW: Koni rear mount design vs Cape

[John Sims]

They are not on my site in the Suspension section of the Technical page.


John Sims, BN6
Aberdeen, NJ
 
http://www.healey6.com


-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of Peter Caldwell
Sent: Thursday, February 25, 2010 10:14 AM
To: healeys at autox.team.net
Subject: Re: [Healeys] Koni rear mount design vs Cape

Steve,  your pictures are very good thanks.

For Everyone's information, I have scanned the original instructions
for the Koni kit and can send as .PDF.

         Peter C
==
At 02:57 PM 2/23/2010, Steve B. Gerow wrote:
>I've had the Cape rear kit installed for several years and even
>though the bottom mounts were bent by the inclusion of too-short
>shocks, the top mount IMHO is a good design and shows no distortion
whatever.
>
>The Cape kit is similiar to the Koni drawings except it replaces the
>two small lengths of angle steel with a full width piece
>approximately 3 ft long. For pictures, see:
>http://www.pbase.com/stevegerow/healey_rear_suspension
>
>However having said this if I had it to do over again I'd go with
>the Putzke kit.
>--
>Steve Gerow
>BN6 with tube shocks
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

You are subscribed as ahbn6 at verizon.net

http://www.team.net/archive