[Healeys] how to remove heater

Simon & Christine Atkinson satkinson7314 at charter.net
Wed Feb 10 17:01:38 MST 2010


I also have a BT7 that is back rolling without any engine or body panels
installed so can help you with any pictures you need. One thing that was a
huge help for me (other than the list) was the photo set that British Car
Specialists sells. Well worth the $$ as they have take pictures of areas
that the average home restorer will question.

Thanks...Simon

-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of I Erbs
Sent: Wednesday, February 10, 2010 3:29 PM
To: healey help
Subject: [Healeys] how to remove heater

Sorry to be asking so many Healey related questions on this site but here
goes:
I am trying to remove my heater on the BT7 so we can sandblast the under
dash area. What I want to know is:
are the phillip's head screws on the bottom braces screwed into the bulkhead
or are there nuts under the asbestos insulation on the engine side of the
firewall?  We have sprayed the piss out of the screws with rust breaker
stuff, but they will not release.

Any advise on how to remove the heater unit?  Also I would like a photo of
the bare trunk (boot) area. I removed the cover material and found a number
of holes and I can not figure out why they are there. maybe if I see some
examples  I figure out if they are needed or not.
Thanks
-- 
I Erbs
Portland, OR
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

You are subscribed as satkinson7314 at charter.net

http://www.team.net/archive


More information about the Healeys mailing list