[Healeys] BN2 rear axle

[Thomas Willig]

Rich,

I was considering this also, but in this case I would get me some new u-bolts.

I have installed everything correctly according to the partslist, but there
might be the case that the new u-bolts that I've used are not specifically
made for the AH 100.


Regards


Thomas


-----Urspr|ngliche Nachricht-----
Von: Rich C [mailto:richchrysler at quickclic.net]
Gesendet: Freitag, 18. September 2009 04:34
An: Thomas Willig; healeys at autox.team.net
Betreff: Re: [Healeys] BN2 rear axle

Thomas,

I would not be cutting those U bolts down any shorter or you'll never get
them back on a second time should you ever need to. Also have you made sure
you have installed everything that should be there including the red fibre
spacer?

Rich Chrysler

----- Original Message -----
From: "Thomas Willig" <twillig at ruda.de>
To: <healeys at autox.team.net>
Sent: Thursday, September 17, 2009 3:31 AM
Subject: [Healeys] BN2 rear axle


> After fitting the rear axle to my BN2, I found out that the threaded
> ends of the u-bolts protrude from the spring plate by over an 1". I
> think that this is a lot and it looks like there might be a chance that
> something could get caught  in it.
>
> I am aware that the u-bolts have to be that long for the fitting of the
> axle, but I wonder if the u-bolts have to be cut down after the axle has
> been fitted?
>
>
>
> Thomas Willig
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler at quickclic.net
>
> http://www.team.net/archive