[Healeys] Update, Need to confirm Testing Process.
Mark LaPierre
lapierrem at sbcglobal.net
Sun Oct 25 18:22:45 MST 2009
Noise update. Noise is in the trany and not the u-joints or driveshaft,
Shoooooot.
Well I was wondering what I was doing to get through the winter and now I
know. Rebuilding
another O/D to replace the one that is in there now. Nice to have a couple
of spare units to fall back on
but still a pain in the ass to swap out. Also the one in place now is my
only 28% ratio that I have.
Oh well life will go on in Healeydom.
I know that removal of the O/D unit is not too bad but the installation can
be a bit tricky if not impossible with the transmission still in the car.
Any tips that anyone has for replacement of just the O/D, while the rest of
the trany is in the car, would be appreciated. Yes I will check the
archives when the time comes.
MARK
----- Original Message -----
From: "Mark LaPierre" <lapierrem at sbcglobal.net>
To: <healeys at Autox.Team.Net>
Sent: Sunday, October 25, 2009 11:45 AM
Subject: [Healeys] Need to confirm Testing Process.
> This is something that I personally have never attempted but it sure makes
> a
> lot of sense.
>
> It was suggested that I unbolt the front u-joint from the trany in order
> to
> isolate a
> clunking noise coming from that area. This would certainly rule out
> noise
> from
> the U-joint going back to the rear end.
>
> So can I just sit in the car and run through the gears and RPMs without
> the
> drive shaft
> connected and not screw up anything. It sounds too easy.
>
> Sure hope the neighbors are away or they may think I have lost it. My
> wife
> already has
> taken this view point.
>
> Mark
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as lapierrem at sbcglobal.net
>
> http://www.team.net/archive
More information about the Healeys
mailing list