[Healeys] motor rebuild
Oudesluys
coudesluijs at chello.nl
Sat Feb 7 10:51:34 MST 2009
Triple Dell'Orto's/Webers 40/45 mm, venturi's around 35/38, larger SS
valves, porting and balancing of the head, free flow exhaust, electronic
ignition to start with.
If you have to build up the engine from scratch, have the crank ground
on very tight tolerances in all bearings, have it tuftrided, polished
and balanced, balance and polish the piston rods increase oil pressure
by using a high volume pump if that is available or rebuild and use
shims under the relief valve spring. Use an electric oil pump to prime
the system before starting up. Use an oil cooler with thermostat.
Lighten the flywheel a little for a bit more accelleration allthough it
does not provide extra BHP, do not over do it as you may wreck the
gearbox, drive shaft and differential because of unsufficiently damped,
by mass, vibrations.
Kees Oudesluijs,
NL
john doe schreef:
> looking to rebuild a 3000 motor but looking to get more hp out of it what are the available options without putting in a cam that would make a rough idle any articles out there
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as coudesluijs at chello.nl
>
> http://www.team.net/archive
More information about the Healeys
mailing list