[Healeys] BJ7 Rear Trim Rail.

BJ8 Healeys sbyers at ec.rr.com
Sun Aug 16 16:08:52 MDT 2009


I've found that using several awls or similar tool instead of the screws to
attach the rail to the drainage channel during trial fit of the top is
helpful.  Also, don't push the clips all the way down -- just enough to hold
the top -- until you are satisfied with the fit.  The barbs on the clips can
tear the top fabric easily when you try to get them off if you push them all
the way. 

Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC  USA

-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of Magnus Karlsson
Sent: Sunday, August 16, 2009 3:48 AM
To: Healey Lista
Subject: Re: [Healeys] BJ7 Rear Trim Rail.

Make sure that it fits the drainage channel during the rebuild but
don't fit it permanently. When you mount the top you start by fitting
it to the rear bow and then fold the rear edge over the rail attaching
it with clips. Then you trial fit the rail to the channel checking the
fit of the top. You have to repeat this process numerous times until
the top fits perfectly. Finally you glue the rear edge and use the clip.

Magnus Karlsson
BorC%s Motor Corporation AB


More information about the Healeys mailing list