[Healeys] Syncro

David Nock healeydoc at sbcglobal.net
Thu Apr 9 09:06:46 MDT 2009


The steel sycro and the Bronze sycros are not interchangable. They  
are different angles and will not work. You will need to remove the  
transnmission and strip it again and install new bronze syncros. And  
next time always replace all three it is easier to do it right the  
first time and not keep going back again and again.



David Nock
British Car Specialists
Stockton Ca 95205
209-948-8767

www.britishcarspecialists.com
.
.

On Apr 8, 2009, at 10:41 PM, PG wrote:

> I just put my rebuilt transmission back into my car...during the  
> rebuild, I
> replaced the 2nd gear syncro as it was fairly worn.   The  
> replacement syncro
> was a steel one (verus the stock brass).
>
>
>
> Everything in the transmission works fine...except the second gear
> syncro...it does not seem to be grabbing and I'm getting a lot of  
> mashing of
> gears on the downshift unless I get the revs right.
>
>
>
> I cant' think of what the issue could be..transmissions are pretty  
> straight
> forward and I'm at a loss as to why I would have this issue..I  
> thought that
> perhaps the steel syncro rings don't grab as well as the brass ones???
>
>
>
> Any input would be greatly appreciated.
>
>
>
> Paul
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healeydoc at sbcglobal.net
>
> http://www.team.net/archive


More information about the Healeys mailing list