[Healeys] Labels

[Bob Haskell]

Mike,

Originally, the tags would have been

	AUD 18F  - front
	AUD 18C  - center
	AUD 18R  - rear

They are available from Todd Clarke at Clarke Spares - 
http://www.clarkespares.com/

AUD 618 is a single HS-4 carb fitted to the 1973 Mini 998 for Canada.  The 
specs call for a different needle and jet, piston springs are the same.

I'd replace the jet assembly.  Leaking fuel above a hot exhaust system 
isn't desirable.  And it hurts your gas mileage too :)

Bob
'62 BT7


Michael Gladwin wrote:
> Gents:
>              Could someone explain to me what the small aluminium  
> triangular label is on the top of the float chamber cover. Fitted  
> under the retaining screw.  Mine are stamped AUD 18F (front):  AUD18F  
> (middle): AUD618 (rear).  The carbs are triple H.S.4's on my BT7 MkII.
> 
> I also note that, in the BMC manual, the forward carb float chamber  
> cover has a fuel inlet and an outlet to feed carb  #2.  However, mine  
> has a T adaptor after the rubber feed line; before the #1 carb  line  
> this then feeds carb #1 and carb #2 in parallel and not in series.   
> The T seems to me to be home-made.  Any comments?
> 
> These questions came when I was removing #3 carb.  I had found a major  
> fuel leak from the #3 feed gland nut on the float chamber (bottom) to  
> the jet nut.  Tightened same - still leaking.  Oh well, when the cuts  
> and abraisions heal I'll take it off again and have another go.
> 
> Mike