[Healeys] Convert to 67 BJ8 engine

Eric (Rick) Wilkins wilko2 at cox.net
Fri Feb 29 12:22:53 MST 2008


Just bolt it in there like any Healey Big six.

You can use your BN4 manifolds, too. Totally worth doing.

Wilko

On Feb 29, 2008, at 4:25 AM, caddi5 at comcast.net wrote:

> Gentlemen,
> I need some advice, I have a 1959 BN4 w/original (tired) 26d engine  
> and is non-overdrive (still looking for complete trans and overdrive  
> unit) I have found a 67 BJ8 engine. The owner of this engine  
> said"Head and bottom end are done"  he states.. head  
> ported,cylinders bored out to next size,new pistons,rods machined  
> shot-peened, crank and flywheel balanced,line bored,new bearings,  
> cam reground,etc. It needs an exhaust manifold and final assembly.  
> My question is what all is required to install this engine into my  
> car ,changes,upgrades,benefits,etc.etc. is it worth doing?
> Thanks in advance!
> Mitch
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as wilko2 at cox.net
>
> http://www.team.net/archive


More information about the Healeys mailing list