[Healeys] BJ8 console trim

[Rich C]

Hi Gary,
I'd suggest hitting your local hobby shop with an original screw in hand to 
compare sizes, and get some very small machine screws and nuts of a suitable 
size. I'd start by eyeballing a 2-56 x 1/2" long and go from there. I think 
a 2-56 machine screw head should slide into that strip.

Rich Chrysler

----- Original Message ----- 
From: <Warthodson at aol.com>
To: <healeys at autox.team.net>
Sent: Friday, February 22, 2008 7:40 PM
Subject: [Healeys] BJ8 console trim


>I have to replace two of the "T" head screws that hold the stainless (or
> chrome) trims strips that run along the sides of the BJ8 center console. 
> The "T"
> end slides into the bottom of the trim strips & the screw portion holds 
> the
> trim against the console. I could just leave two of these off but would
> prefer to replace them. Does anyone have a source for these or a 
> suggestion on  how
> you have made replacements?
> Thanks,
> Gary Hodson
>
>
>
> **************Ideas to please picky eaters. Watch video on AOL Living.
> (http://living.aol.com/video/how-to-please-your-picky-eater/rachel-campos-duffy/
> 2050827?NCID=aolcmp00300000002598)
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler at quickclic.net
>
> http://www.team.net/archive