[Healeys] steering box rebuild

Alan Seigrist healey.nut at gmail.com
Sun Feb 3 22:50:47 MST 2008


Also try Steve at Cape International or Dennis Welch.  They will both have
piles of used LHD boxes around.  Another option is to check with Bill
Bolton.


On Feb 4, 2008 1:47 PM, Ray Juncal <healeyray at yahoo.com> wrote:

> Larry
>    Thanks for your reply.  The steering boxes I'm working on are the early
> ones with a triangular end plate with the olive for the stator tube.  It
> sounds like you have a later box.  The change came near the end of the BN-2
> run and that box was used to the mid-BN-6 run.
>    Mike Salter suggests maybe one of you Australian  boys might have a
> good used one left over  from your  conversion to  right hand drive.  So
> anyone down there in the Antipodes  sitting on a left hand  steering box
> with a good worm gear??
> Regards
> Ray juncal
>
> Larry Varley <varley at cosmos.net.au> wrote:           Ray
>  I had this pitting problem with my 3000 steering box worm ( a second hand
> one I got to convert my box to RHD). You say BN1 and 2 boxes, isn't the worm
> on the later BN1 and 2 boxes rivetted onto the splined steering shaft like
> the early 3000 boxes? I removed the worm, re machined the pitted area, re
> hardened and refitted. Had to heat the end of the shaft and worm red hot to
> get the riveting to close down to get the worm off. I then shimmed the
> bearings to allow for the reduced length between the bearings from the
> machining. All the new worms I have seen aren't made with a high spot in the
> middle like the originals, so can have a tight spot in them over their
> range. I would try to fix yours. I have a left hand drive worm that came out
> of my car that is in good condition, but it has been red hot on the end and
> would need re hardening.
>  Cheers
>  Larry Varley


More information about the Healeys mailing list