[Healeys] release bearings

Skip Saunders tfsbj7 at mindspring.com
Tue Dec 23 07:10:07 MST 2008


What is the "fix" for these thicker release bearings?.... Does one have to
measure them pre-installation and then take them someplace to be ground
down?

Thanks
-skip-
BJ8

-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of Healeyguy
Sent: Sunday, December 21, 2008 7:26 PM
To: healeys at autox.team.net
Subject: Re: [Healeys] release bearings
<snip>

As an aside to this, some of the newer Country brand release bearings for
the 9 1/2" clutch have been 1/8 inch or more thicker than the standard.
This causes a constant contact on the carbon when first installed and as a
result a smoky clutch.  Reference: See my email request of six+ months ago.
The bearing wears down quickly but as a result destroys the tight fit on the
carbon doughnut and subsequent bearing failure. No fun!
Aloha
Perry


More information about the Healeys mailing list