[Healeys] BJ8 distributor drive

[bluechip]

I think its way cool when two of the most prolific and helpful listers 
(Michael and Rich) respond (and agree, btw) within 20 minutes, and four 
minutes apart.  Love this list!

Jim Smith



----- Original Message ----- 
From: "Rich C" <richchrysler at quickclic.net>
To: <healeys at autox.team.net>; "Stephen Hutchings" <s.hutchings at rogers.com>
Sent: Friday, October 19, 2007 5:38 PM
Subject: Re: [Healeys] BJ8 distributor drive


> Stephen,
>
> There are the two hex head carscrews that hold the distributor clamp plate
> to the spacer casting. Under that there is a single bolt with it's head 
> set
> into a counterbore in the surface of the spacer. Unscrew and remove that 
> as
> well and the spacer should pull straight out. The spacer is sleeved into 
> the
> hole, but should come right out.
>
> Rich Chrysler
>
> ----- Original Message ----- 
> From: "Stephen Hutchings" <s.hutchings at rogers.com>
> To: <healeys at autox.team.net>
> Sent: Friday, October 19, 2007 5:20 PM
> Subject: [Healeys] BJ8 distributor drive
>
>
>> Hi Folks, here's another silly question.
>> I have to remove my distributor spindle drive in preparation to pull
>> out the cam, and I'm finding one item rather stubborn. I was
>> expecting the piece of casting that is left after you take off the
>> distributor,(about 3/8" thick, with 3 holes ) to come off rather more
>> easily than it is. Is it not just a gasket between it and the block?
>> I have tried some heat, but I don't want to force anything. The
>> spindle won't pull out with this piece in place......what am I
>> missing?
>>
>> Stephen, BJ8
>> _______________________________________________
>> richchrysler at quickclic.net
>>
>> Healeys at autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
> _______________________________________________
> bluechipracing at snet.net
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys