[Healeys] soldering fitting to steel fuel line

[Manuel Formosinho Sanchez]

Gary
If you don't have previous experience soldering, send it to a pro, you will
not regret it.
Regards
Manuel Sanchez
58 Bug
55 BN1
69 E Type


-----Mensagem original-----
De: healeys-bounces+manuelfs=emparque.pt at autox.team.net
[mailto:healeys-bounces+manuelfs=emparque.pt at autox.team.net] Em nome de
Warthodson at aol.com
Enviada: segunda-feira, 30 de Julho de 2007 14:31
Para: healeys at autox.team.net
Assunto: [Healeys] soldering fitting to steel fuel line

I need some advise on how to solder the original brass/bronze fittings onto
the end of new steel fuel line. I have tried cleaning both parts with scotch
brite pad & using rosin flux & heating with a torch, but I cannot get the
solder
to flow onto the steel line. I was hoping to avoid using acid flux because it
seems so hard to completely remove any traces resulting in corrosion in the
area of the joint. Does anyone have any actual experience in this area?
Gary



************************************** Get a sneak peek of the all-new AOL at
http://discover.aol.com/memed/aolcom30tour
_______________________________________________
manuelfs at emparque.pt

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.476 / Virus Database: 269.10.25/926 - Release Date: 29-07-2007
23:14


No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.476 / Virus Database: 269.10.25/926 - Release Date: 29-07-2007
23:14