[Healeys] FW: scuttle seals

[John Sims]

-----Original Message-----
From: John Sims [mailto:ahbn6 at optonline.net]
Sent: Wednesday, July 18, 2007 4:45 PM
To: 'Rich C'; 'tricarb at aol.com'; 'healeylist'; 'Bob Haskell'
Cc: 'Lyn'
Subject: RE: [Healeys] scuttle seals

The below including photos are now published on my web site on the Technical
ArticlesPages.

John Sims, BN6
Aberdeen, NJ
 
www.healey6.com
 


-----Original Message-----
From: Rich C [mailto:richchrysler at quickclic.net]
Sent: Wednesday, July 18, 2007 2:16 PM
To: tricarb at aol.com; healeylist; Bob Haskell
Cc: Lyn; John Sims
Subject: Re: [Healeys] scuttle seals

Hello all,

I just finished installing a pair of roadster scuttle seals that came from
AH Spares. Although they are awkward by design to install at the best of
times, I found that these gave no more trouble than the usual struggle! This

is a situation that calls for about 4 hands at once, though there isn't room

for them.

The fitting of them involves working them into position and marking where
the holes for the split pins will need to be located. Then it's off the car,

punch the holes as needed and split pins with flat washers (not supplied)
must be pressed into the lower flap, the unit repositioned on the car, and
the pins pushed up through the locating holes on the cowl side flange and
fender rear curved flange.


ETC.