[Fot] Thrust Bearing fabrication question?
Richard Good
goodparts at verizon.net
Thu Feb 23 08:49:23 MST 2023
Dave,
I use brass pins in the lower half only. If you pin the upper half you have to remove the crank to replace the thrust washer.
Richard GoodGood Parts Inc
On Thursday, February 23, 2023 at 10:41:57 AM EST, David Cutter via Fot <fot at autox.team.net> wrote:
Amici, fabricating some full 360 degree thrust bearings for the first time. What is the recommended method for fastening them? Pin or other fastener? Fasten both halves or just the upper half?
Thanks!DaveSpitfire #42
_______________________________________________
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20230223/e4012f38/attachment.htm>
More information about the Fot
mailing list