[Fot] TR6 forged pistons wanted

[Robert Lang]

 Hi - I hope you get some good offers, but the other responses I've seen so far are more likely to pan out: British Frame and Engine, APTFast, TSImported, etc.
I'm sure I'm not the only one out there that has the situation, but I have several partial sets - .020 over, .050 over from broken engines. The .050 overs were from a TR6 running SCCA GT3 motor - the driver broke TWO pistons. In theory, you can get matching pistons for those sets from the manufacturers, but good luck finging a job number or other info. that you could use to get one or two pistons cut to complete a set. Especially, if the pistons are 20+ years old.

If you wind up getting a custom set, my advice is to spend some extra $$$ and get 8, that way you have a couple of spares for the next engine which will be needed if/when you break a crank or chuck a rod.
Also, seems to me you should be looking at building a GT6 engine - it is much more forgiving if you want to spin the engine fast, like more than 6000. Going for huge power is over-rated unless you just want to spend a lot of $$$.

Just sayin'.
Regards,Bob Lang

    On Monday, August 26, 2019, 11:17:50 PM EDT, Michael Zbarsky via Fot <fot at autox.team.net> wrote:  
 
 Anyone have a set kicking around they’d part with? Or suggestions on where to source them?
Thanks, Mike ZTriumph 2000 race car (in need of engine)


_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/robertlangtr6@yahoo.com


  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20190827/c5056dca/attachment-0001.htm>