[Fot] ARP rod bolt torque

[Jason Ostrowski]

Assembly lube the bottom half of the stud and tighten them down progressively with a stud socket. Make sure all surfaces are totally clean. Place gasket and head on and a small dab of assembly lube on the head nuts. torque equally in several stages in the proper order according to manual. Torque to a final 70 lbs. cold. then check twice hot (once after a short warm up and again after a 20 or 30 minute session). To 70 lbs. 
Jason Ostrowski
Friendly Ghost Racing
1969 Triumph GT6+ racecars 

Sent from my iPhone

> On May 30, 2017, at 8:21 PM, Chuck Arnold and/or Kathleen Kelley via Fot <fot at autox.team.net> wrote:
> 
> This was the hot oil thread. Tore engine down. Nothing in the sump. Checked all bearings. All ok. Thrust washers ok, but little clearance.
> 
> Now need to torque the ARP rod bolts in the Pauter rods. Looking for help as to what is the proper value.
> Thanks,
> Chuck
> 
> _______________________________________________
> fot at autox.team.net
> 
> http://www.fot-racing.com
> 
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/jason@multivintage.com
> 
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20170531/bce79167/attachment-0001.htm>