[Fot] Clevite rod bearings

[toodamnfunky at comcast.net]

It looks like Mahle/Clevite are going to discontinue them at least on the standard bearing size. 
Any suggestions on an alternate? I run the Tri-metal mains. I need to get two sets, one standard and one 
.010 under so I can get some measurements. I have a crank that's right on the edge of running a standard 
bearing but I won't know for sure until I can measure the ID's with bearings in place. 
Thanks for the input as always, 
Jim Gray 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20170425/2ccf19c4/attachment.htm>