[Fot] TR4 Block work suggestions

[STEPHEN BOROWSKI]

 Hello All,I disassembled my TR4 race car engine this past week. Last time I rebuilt it was 1987. Last time I raced it was 1988. Probably had five or six race weekends on the engine but its been sitting for almost twenty years! It is amazing everything looks very good. Rod and Main bearings show minimal ware and the same with the pistons and liners. G3 cam and followers including head and valves all look good. Cam bearings look questionable...
So I plan on installing new cam bearings, Rods & Mains. Any suggestions as to what brand and where to buy them?I will deck the block. Any suggestions as to other machining I should do to the block? 
The crank looks fine but I haven't measured it yet. What clearances should I run?I do plan on balancing and polishing it.
Thanks for any input.
Steve and son MatthewFlorida TR4



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20160627/491b3ca0/attachment.htm>