[Fot] TR4 axle shafts

[Tony Drews]

I like it.  Castellated nut hubcap.

Tony

At 05:38 PM 1/21/2014, you wrote:
>I wonder if Southwick can machine axles with a threaded outer shaft 
>to hold a stock washer and castellated nut?
>
>---- MadMarx <tr4racing at googlemail.com> wrote:
> > Anybody knows the diameter of the Southwick axle?
> > I managed to do a successful calculation with a spline design and the stock
> > diameter of 33.02mm (I used 33mm = 1.299").
> > The steel needs to be quite good with a surface hardening of 0.11" depth.
> >
> > As Steel I would like to use X19NiCrMo4 if this is available at reasonable
> > cost.
> > Any suggestions?
> >
> > Chris
> > _______________________________________________
> > fot at autox.team.net
> >
> > http://www.fot-racing.com
> >
> > Donate: http://www.team.net/donate.html
> > Archive: http://www.team.net/archive
> > Forums: http://www.team.net/forums
> > Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/fot/rkramer3@austin.rr.com
>_______________________________________________
>fot at autox.team.net
>
>http://www.fot-racing.com
>
>Donate: http://www.team.net/donate.html
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage: 
>http://autox.team.net/mailman/options/fot/tony@tonydrews.com