[Fot] TR4 diff disassembly

[Bill Babcock]

If you put the banjo in a press just a relatively gentle vertical squeeze will spread the case horizontally and release the diff with little drama. 
On Sep 26, 2013, at 7:25 PM, "Joe Boruch" <jaboruch at netzero.net> wrote:

> I have aways been able to pry the diff out with extra large screw drivers as pry bars.  Joe(B)
> 
> From: Scott Janzen <Janzen at REcatalyst.com>
> To: 'Friends of Triumph' Triumph <fot at autox.team.net>
> Subject: [Fot] TR4 diff disassembly
> Date: Thu, 26 Sep 2013 22:12:19 -0400
> 
> So, i am pulling apart the rear axle to send it to Southwick for conversion.  I'm working without a shop manual - and want to pull the differential out of the housing.  I've removed the bearing caps.  Do I need Churchill Spreader xyz, and is there a good/cheap substitute?  It does not want to pop out with the persuasion of a pry bar.
> 
> BTW, there's a Detroit locker . . . any special instructions?
> ____________________________________________________________
> 30-second trick for a flat belly
> This daily 30-second trick BOOSTS your body's #1 fat-burning hormone
> http://thirdpartyoffers.netzero.net/TGL3231/5244ecdd827986cdd2c70st04duc
> _______________________________________________
> fot at autox.team.net
> 
> http://www.fot-racing.com
> 
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/billb@bnj.com
> 
>