[Fot] TR-3/4 main cap bolts / ARP

[MORDY DUNST]

What I did was just measure the entire legnth of the bolt and added a bit 
(can't recall) ... went to my local fastener place 
www.specialty-fasteners.com  and asked for off the shelf studs and wavy 
washers with 12 point nuts.  Never an issue since.


Mordy

M.N.Dunst
Gasket Works USA, LLC
www.Headgasket.com
626.358.1616 ph
626.628.3777 fx

Triple R Munitions, Inc.
Class 6  Certified F.F.L.
626.201.9471
GMT -8 Pacific


----- Original Message ----- 
From: "Tony Drews" <tony at tonydrews.com>
To: <fot at autox.team.net>
Sent: Tuesday, January 12, 2010 7:49 PM
Subject: [Fot] TR-3/4 main cap bolts / ARP


> Anyone have info on dimensions for TR-4 main cap bolts?  The manual shows 
> 1/2" UNC but not the length.  I'm trying to figure out what ARP bolts you 
> would buy to replace the stock bolts, and also one that's 1/2" longer to 
> allow for "strapping" the center main.  If I had the dimensions (length) I 
> could try to cross reference the engines that ARP lists main cap bolts 
> for.
>
> Thanks in advance,
> Tony Drews
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Suggested annual donation $12.96
>
> You are subscribed as gasket.works at gte.net
>
> http://www.fot-racing.com
>
>
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
> Brought to you by Team.Net consulting - Unix software specialist.