[Fot] Caliper Bolt Torque

[n197tr4 at cs.com]

I  surmise from my own factory/corporate background that TORQUE SPECS and
Replacement Seals were not readily available to the general public because of
liability issues with critical components.




-----Original Message-----
From: MadMarx <tr4racing at googlemail.com>
To: fot at autox.team.net
Sent: Wed, Jan 6, 2010 4:02 am
Subject: Re: [Fot] Caliper Bolt Torque


>From Buckeyes Triumph:
irling "split" calipers should not be separated for any reason.  They were
ot designed for separation and reassembly and proper torque specifications
re not known, other than the inner and out bolts are torqued differently.
he inside bolts are 7/16" diameter and the outside bolts are 3/8" diameter.
I torqued the outside 3/8" bolts to 40 ft-lbs and the inside 7/16" bolts to
0 ft-lbs.

----Urspr|ngliche Nachricht-----
on: fot-bounces at autox.team.net [mailto:fot-bounces at autox.team.net] Im
uftrag von Geoff Byrne
esendet: Montag, 4. Januar 2010 11:16
n: FOT
etreff: [Fot] Caliper Bolt Torque
Amici
oes any know the correct torque for the bolts holding the 2 halves of a TR6
rake caliper
eoff Byrne
R6 racer down under
ou are subscribed as tr4racing at googlemail.com
http://www.fot-racing.com

ot at autox.team.net
ttp://autox.team.net/mailman/listinfo/fot
Brought to you by Team.Net consulting - Unix software specialist.
Suggested annual donation $12.96
You are subscribed as n197tr4 at cs.com
http://www.fot-racing.com

ot at autox.team.net
ttp://autox.team.net/mailman/listinfo/fot
Brought to you by Team.Net consulting - Unix software specialist.