[Fot] Detroit Locker

[Kas Kastner]

I have also done this type fit many times with center punch and hammer.
---- Larry Young <cartravel at pobox.com> wrote: 

=============
This a poor boy approach that some of you will scoff at, but I've done 
it and it works.  Have you ever heard of a "strawberry fit"?  Peck 
around on the surface with a punch, then use loctite sleeve retainer as 
Randall suggested.  This is not a good approach if you're planing to 
take the bearing off many more times.  In that case, you might be able 
to turn the surface down to the size of a different bearing, or you 
could turn it down and sleeve it back to size.
Larry

Randall wrote:
>> What can be done to get these 
>> bearing surfaces built back up to spec?
>>     
>
> There are several Loctite products designed for this purpose.  I've had good
> luck with RC609, though not on a diff.  RC603 might be a better choice,
> though, as it's supposedly stronger and tolerates contamination better.
> http://207.250.200.229:8080/1/doc?id=26269
> http://tinyurl.com/n9276o
>
> Randall
>
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> http://www.fot-racing.com
>
> You are subscribed as cartravel at pobox.com
>
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
You are subscribed as kaskas at cox.net

Fot at autox.team.net
http://autox.team.net/mailman/listinfo/fot


--
Never be beaten by equipment