[Fot] 2 questions

[Bill Babcock]

I second that. The pins are pushed into holes in the tubing very close  
to the edge of the tube and it can easily break out. I've had it  
happen to two rear ends. The banjo welds nicely as do the tubes. I run  
short beads about an inch long, spaced about an inch apart. Permanent  
fix.


On Aug 19, 2009, at 7:11 PM, Joe Boruch wrote:

> Teriann, weld the axle tubes to the diff housing.  The pins work  
> themselves
> loose, so also weld the pins in.  The housing is basically cast  
> steel and will
> weld fine with a mig welder.  Joe(B)
>
> ---------- Original Message ----------
> From: "TeriAnn J. Wakeman" tjwakeman at gmail.com
>
> #1 I have gear lube weeping between the diff housing and the axle  
> tube.
> Assuming that doesn't mean an axle tube is about to fall off (I hope
> not) what is the best way to seal this weep?  Braze the junction all  
> the
> way around?  or ??
>
> Teriann
> ____________________________________________________________
> Compete with the big boys.  Click here to find products to benefit  
> your
> business.
> http://thirdpartyoffers.netzero.net/TGL2231/fc/BLSrjnxUki9SBXpRqqlFzfWFNMXgT2
> x4zMgHdxHwGKuBC4h19L9lNFAfx2A/
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> http://www.fot-racing.com
>
> You are subscribed as billb at bnj.com
>
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot