[Fot] TR4 timing advice needed please

[Bill Babcock]

I run 35 total advance

Sent from my iPhone

On Sep 8, 2008, at 9:19 PM, "Tony Drews" <tony at tonydrews.com> wrote:

> As I recall, I've got about 12 degrees at "idle" (a bit over 1000  
> rpm), straight line "curve" to 32 degrees at 3000, then slightly  
> increasing advance as the RPM's increase from there.  I think it's  
> 34 degrees at 6k.  Not that far off of your settings.
>
> - Tony D
>
> At 05:54 PM 9/6/2008, Jim Gray wrote:
>> Greetings all,
>> I could use a bit advice on timing. I have one of the new 1-2-3  
>> distributors out of the Nederlands.
>> It's an electronic distributor with programmable timing curves.
>> The curve I have at the moment is 10 degrees at 500 - 1000 , 27  
>> degrees at 2000  and 33 degrees at 4500
>> there are 16 different curve settings available. Coming off the  
>> throttle it falls flat on it's face and I have to coax it up to
>> 3000 where it takes off pretty good. I just installed a set of  
>> Mikuni HSR 45's and they ran really well before I installed
>> the distributor. I'm not getting any noticable pinging out of it. I  
>> know I still have some jetting to get through
>> but as I mentioned, It didn't have this problem before the  
>> distributor went in.
>> Any advice would be appreciated.
>> Jim Gray
>> RMVR # 102
>> _______________________________________________
>> http://www.team.net/donate.html
>>
>> Fot mailing list
>> Fot at autox.team.net
>> http://autox.team.net/mailman/listinfo/fot
>
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20080909/6db2fb89/attachment-0003.htm>