[Fot] Oil pressure problem solved

[Bill Babcock]

I assume you are turning the shaft with the drill in reverse.


-----Original Message-----
From: fot-bounces+billb=bnj.com at autox.team.net on behalf of James Gray
Sent: Sat 9/29/2007 9:48 AM
To: fot at autox.team.net
Subject: [Fot] Oil pressure problem solved

The fact I was not using an old pump drive shaft or something of similar
diameter seemed to be the cause.
I chucked one up in the drill & gave it a spin and just about pegged the
gauge.
I suppose I'm glad it was not something stupid I did during assembly.
If it was, the whole motor would be suspect. Now, to get it fired up :)
Thanks to all who advised.
Jim Gray
# 102 RMVR
billb at bnj.com
Fot mailing list
Fot at autox.team.net
http://autox.team.net/mailman/listinfo/fot