[Roadsters] Oil pan gasket

[Mike Harper]

That method sounds correct.  You may want to start with the center of the pan
and thigten snug working to the ends, then repeat.  Do not overtighten, as
that is what causes leaks, the pan seal will deform easily if overtightened.
A cork gasket and a light coating of sealant should work beautifully if your
surface is straight.  Check it with a straight edge before re-installing, and
hammer it straight if it has warps.

Mike Harper, CAI, AARE
Harper Auction & Realty
843-729-4996
"Experience Sells"

www.AuctionMyRealEstate.NET


--- On Wed, 9/30/09, jeremy mayne <jeremymayne at msn.com> wrote:

> From: jeremy mayne <jeremymayne at msn.com>
> Subject: Re: [Roadsters] Oil pan gasket
> To: stebharvey at ameritech.net, datsun-roadsters at autox.team.net
> Date: Wednesday, September 30, 2009, 9:55 AM
> I don't know if this is the "correct"
> method, but when I built my stroker
> motor, I used a new cork gasket, new lock washers, and no
> gasket sealer.
> After installing the bolts, I worked my way around the pan
> multiple times,
> tightening to spec each time (I think 12lbs, but don't
> quote me on that).  No
> leaks so far.
>
>
>
> Jeremy Mayne
>
> 70 SPL stroker (sadly unused right now)
>
>
>
>
>
> > From: stebharvey at ameritech.net
> > To: datsun-roadsters at autox.team.net
> > Date: Wed, 30 Sep 2009 06:36:41 -0500
> > Subject: [Roadsters] Oil pan gasket
> >
> > Group,
> >
> >
> >
> > Can someone provide insight into the correct method
> for installing a new
> oil
> > pan gasket on a 1600 engine? Also, is it true that the
> same gasket can be
> > used on the 1600 and 2000 engine?