[Roadsters] help wanted volvo brake conversion

[Pat Horne]

Gary is probably correct, but it could be that the break pedal linkage 
is too long, not allowing the master cylinder piston enough room to 
uncover the bleed hole in the cylinder. When the break fluid heats up it 
expands, which, if the bleed hole is covered, will slowly apply the 
breaks. Let them cool off and things work fine again.

Peace,
Pat

Thusly spake Francis Anand, On 3/23/2009 4:56 PM:
> Hey guys i need help . I did a volvo brake conversion on 70 roadster.I used
> 311 site for info. Used original new brake master cylinder .Now the problem is
> the brake is hanging on me.
> Both the front wheels gets hot and locks doesnt turn. We took all air
> bubble out  .  I bled rear  rt first    rear left   front rt    front lt.. The
>  front caliper i did top  inside , bottom inside  ,and then outside.    Also
> tried doing reverse method  left front    right front    left rear   right
> rear   . Is there something that i am doing wrong?          
> ________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as pat at hornesystemstx.com
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters
>   
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.0.238 / Virus Database: 270.11.24/2018 - Release Date: 03/23/09 06:52:00
>
>   

-- 
Pat Horne, Owner, Horne Systems 
(512) 797-7501 Voice		5026 FM 2001
Pat at HorneSystemsTx.com	Lockhart, TX 78644-4443
www.hornesystemstx.com
-- We support Habitat for Humanity - a hand UP, not a hand OUT --