[Roadsters] Temp Sensor

[Pete Peters]

Here are pics:

<http://i97.photobucket.com/albums/l221/ppeters914/roadster%20parts/R16water
tempsensor2a.jpg>
<http://i97.photobucket.com/albums/l221/ppeters914/roadster%20parts/R16water
tempsensor1a.jpg>

If the above links get broken, here are TinyURL links:

<http://tinyurl.com/3ujktk>
<http://tinyurl.com/4jfq5k>

Hope this helps.

Pete


-----Original Message-----
From: datsun-roadsters-bounces+ppeters914=comcast.net at autox.team.net
[mailto:datsun-roadsters-bounces+ppeters914=comcast.net at autox.team.net] On
Behalf Of Daryl Smith
Sent: Tuesday, September 30, 2008 9:25 AM
To: Steve Harvey; datsun-roadsters at autox.team.net
Subject: Re: [Roadsters] Temp Sensor

Steve,

If this is indeed a 1600 R series engine/head, there are 2 theaded holes in
front of the #1 cylinder exhaust manifold. If there is not it has been
welded up, or it is not a 1600 head. I believe the 1500 head is the same,
don't know about an H20 head. If there is not one there, you may not have a
1600 R series engine even......

I would suggest you have a VERY close look at it. You may be able to tell if
it has been welded up or has a plug in it.........

A picture of the area, with a link, because attachments are deleted at the
server,  would be helpful.

Are you sure the stock temp sensor does't wotk?

Daryl


From: "Steve Harvey" <stebharvey at ameritech.net>

> Group,
>
>
>
> Thanks for the replies. There's only one threaded fitting on the front 
> of the intake manifold so I plan on installing a "T" which will allow 
> me to install the temp. sensor and leave the current piping that runs 
> to the manifold. This should solve the problem. Now to figure out 
> where to install the temp gauge in the dash area so it looks good but 
> won't cause a trip to the clinic for stitches.
>
> Steve
Datsun-roadsters mailing list

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/datsun-roadsters