[Roadsters] brake line suppliers?

[Brad Lustig]

Since they've done your lines, they should have the pattern on hand.  I 
would rather take the time and send your own lines, though.  They said 
they had the lines for my '48 Dodge, but when I got them, they were 
completely wrong.  Not only the wrong bends, but also the wrong 
diameter!  Once I sent them my old lines, they were able to fab up exact 
replicas.  Wasn't completely happy with the results because my lines had 
been replaced at some point in the past, so they weren't factory bends.  
If I were to do it all over again, I'd make my own up.  Much easier to 
do than you would think (stainless is a bit harder to do, though)

Brad
Mount Pleasant, SC

pjmill wrote:
> Another good source is inline tube:
>
> http://www.inlinetube.com/ 
>
> I shipped all my 1600 brake and gas lines and that little oil line that
> feeds the distributor to these guys and they duplicated exactly every tube
> in stainless steel -- did a great job!
>
> Paul