[Bricklin] Replacement Drive Shaft for 700r4 transmission swap

[Greg Schroeder]

OK, I almost have the engine rebuild and the 700r4 transmission installed.  I
am just about 1/4 inch off of installing the motor mounts.  I had to remove
them to get the transmission past the firewall and removing these and
installing them after the engine is installed it a real pain.  It looks like I
am going to be about three inches short on the drive shaft as I expected from
comparing the Torque Command to the 700r4.  What are my options to resolve
this issue?

Greg 0036