[6pack] More brakes

[Rochlin Robert]

Hi Rick,
	I have spare O ring type seals for the brake warning switch block.  I can send you a couple if you need them.
	Best,
	Bob

> On Aug 2, 2019, at 8:33 AM, Richard Lindsay via 6pack <6pack at autox.team.net> wrote:
> 
> Hey all,
>    Today, before the Houston heat grows too great, I hope to address the rear brake hydraulics on my '75 TR6 project car. Specifically, I will inspect all of the pipes, flush them clean, then replace the rear flex hose. Work from the distribution block on to the new slave cylinders has already been completed.
>    I already finished work on the front system and cleaned up the area. Here's how it looks now. (Remember, this is to be a nice driver, not a show car.)
> 
> http://aubard.us/75_Triumph/20190731_103230.jpg <http://aubard.us/75_Triumph/20190731_103230.jpg>
> 
>    The switch on the pressure differential warning system, is bad and the piston seals leak. Until replacement parts can be sourced, the switch port is sealed with a short 3/8-fine bolt and a thick rubber washer. Doing so leaves the system a straight through junction, if with a tiny bit of leakage between chambers.
> 
> Rick
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> 
> 6pack at autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
> 
> Unsubscribe/Manage: http://autox.team.net/mailman/options/6pack/rrochlin@comcast.net
> 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/6pack/attachments/20190802/1e32d3f2/attachment.html>