[6pack] Moss SU Upgrade for TR6

[J B]

My 240z has the SU's with the same tubes. They covered with fuel ine tubes that run to the air filter housing. When people us K&N filters they either route the fuei over flow lined to the K&N filter or run it below the exhaust manifold. When I first bought the car (and was driving it home from the PO's house) there were short lines attached. The carbs shot out some gas that it hit the hood and dripped onto the manifold. This started a small fire under the hood. I noticed the paint bubbling on the hood and pulled over to find the rubber lines on fire. Lucky I noticed it. 

So do not drive it until routed past the manifold or into the air filter.

Good luck,

JohnB
Chicago

74 TR6

--- On Sun, 5/23/10, Bob <yellowtr at adelphia.net> wrote:

> From: Bob <yellowtr at adelphia.net>
> Subject: Re: [6pack] Moss SU Upgrade for TR6
> To: "Alex" <ambritts at bellsouth.net>
> Cc: "*Six Pack" <6pack at autox.team.net>
> Date: Sunday, May 23, 2010, 5:48 PM
> On Sunday, May 23, 2010 06:01:21 pm
> Alex wrote:
> > Hi Bob,
> > When these were first put on, gas flowed heavily from
> these tubes. The
> > original owner needed to install a pressure regulator
> between the
> > mechanical fuel pump and the carbs. The pump was
> putting out 6 lbs of
> > pressure and the carbs required 1-1.5 lbs forcing gas
> out of these tubes.
> > They appear to work find now, but safety is a key
> issue as they did come
> > close to leaking on the exhaust manifold. Just does
> not seem right.
> > 
> > I like the carbon canister venting, except hers was
> removed. My TR3 tubes
> > are vented back into the air intake filter where it is
> consumed back
> > through the carb opening.
> > 
> > Alex
> 
> Alex,
> 
> I replaced the mechanical fuel pump with a Facet
> electronic. I use a regulator 
> set at 2 PSI. 
> 
> I use the same setup on my 3 and 4. The 3 with SU H6 and
> the 4 with HS6. All 
> set at 2 PSI. Both the 3 and 4 have run with out a problem
> for the 3 years 
> since I switched to electronic fuel pumps.
> 
> I don't expect any problems with the 6 with the same
> setup.
> 
> The carbs will have to sit in their boxes for now as the
> engine is all masked 
> up while I continue on the body work/paint etc. 
> 
> Bob
> _______________________________________________
> 
> 6pack at autox.team.net
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/6pack/jb_2email@yahoo.com