[6pack] Bonnet buffer wedge position

[Tomislav Marincic]

Hello,

I need to install the 4 rubber wedges that keep the hood/bonnett from rubbing against the inner fenders when it's down. The problem is that I replaced the tops of my inner fenders, so the holes are gone. I'd like to position them as close as possible to the original location.

Could someone please take a moment and measure the location of the center of their bonnet buffers from a reference point, such as the cowl panel or the bonnet support cones? I notice there's a raised boss stamped in one place toward the aft side of the inner fenders; does one set of buffers go on this? Finally, does the flat bottom side of the buffers go all the way down against the fenders, or are they "raised" to some degree? 

Thanks again, Tom
CC55483L

http://www.triumphowners.com/735