In a message dated 24/07/01 10:08:10 AM Pacific Daylight Time,
Rogsie@telesistech.com writes:
> Check your front wheel bearings. If they are worn or just losely adjusted you
> will get a good case of pad "knock-back".
Good advice - make sure the end-float is within spec (not too tight, or they
will heat up).
> >>> John Cowan <jfcowan@pacbell.net> 07/24/01 12:21PM >>>
>
> Took the TR-3 out autocrossing for the first time and enjoyed it quite al
> ot.
Either your expectations were modest, or........
Actually, the TR is not too bad on a slalom course as it is rather stiff -
get it out in big radius corners, and you'll quickly find it's Achilles heel
- the axle will bottom on the frame and then lift and no more power from then
on. You need a much heavier sway bar for racing than for slalom for that
reason.
Bill
|