The last time I had custom rings made, I was told to ship them a piston.
Doing it "by the numbers" may result in something being off. It's better
to send them a piston that to have to iterate on the custom rings. I used
Deves, but I have heard from some people that they don't like Deves.
Round up the usual suspects, as they say. Any of the major racing ring
suppliers should be able to make you a custom set.
Steven Silverstein wrote:
>
> I need to replace the rings on a set of old J+E Pistons.
>
> These are old pistons (35+ years) which are virtually NOS . The mechanics
> notes from 1967 calls out the following specifications for the rings:
>
> Ramco 1195 MSTD 3.25"x3/32" Top + oiler
> Ramco CM 200 3.25" x 5/32" middle
|