I need to replace the rings on a set of old J+E Pistons.
These are old pistons (35+ years) which are virtually NOS . The mechanics
notes from 1967 calls out the following specifications for the rings:
Ramco 1195 MSTD 3.25"x3/32" Top + oiler
Ramco CM 200 3.25" x 5/32" middle
Typically, I buy "sets" of pistons and rings together. I am guessing Ramco
is out of business. I was going to call J+E in the morning and ask about
their rings. Being that I have never spec. separate rings are the
dimensions above sufficient to order new rings?
I never have really thought about this before but it seems like it should be
enough information...
Thanks for any advice.
Steve
|