My tr2 had the Triumph badge on the back. Though not original for it, I
intended to keep it until i realized it was off center by about an inch.
I've had people ask me if i dechromed it...
On Jan 21, 2013 7:06 PM, "Randall" <TR3driver@ca.rr.com> wrote:
> > Wondering what techniques listers have used to fasten the badges (&
> > letters) to the front clip and rear deck (TR2).
>
> I believe a TR2 should have only the badge, no letters. Late TR3s did
> sometimes have the Triumph script in the rear, but mine doesn't.
>
> > Anyone use anything else?
>
> I'm not quite sure where they came from, but I used spring nuts that have a
> hex formed into them, so they can be tightened with a nut driver. Similar
> to these
> http://goo.gl/LCKNb
>
> To use what appear to be the factory type flat spring nuts, I think you
> should support the badge in some fashion and then use a round hollow tool
> (perhaps a very small socket) to tap the spring nut down and lock it in
> place. That should provide some spring action to hold the badge securely
> against the nose. The fingers of the spring nut should dig into the post,
> so that it won't come apart unless something breaks. To disassemble, cut
> the spring nut with a Dremel cutoff blade.
>
> -- Randall
>
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/ccsimonsen@gmail.com
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|