I had the same issue of the movement, worried about the paint, but used a
dab of clear silicone on the back of each post. Now they are all secure and
would be fairly easy to remove is needed.
Bill
Bill Beecher
'58 TR3A TS/30766L "Tarbaby"
'62 TR3B TCF/2549L " Aunt B" (in rehab)
www.triumphowners.com/1566
'68 Land Rover Series IIa 88" "The Beast"
"If you think you have everything under control... You're driving too slow"
M.Andretti
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Andrew Uprichard
Sent: Monday, January 21, 2013 4:34 PM
To: 'Angelo Graham'; triumphs@autox.team.net
Subject: Re: [TR] TR2/3 Badge fastening
I used spring clips but the rattling drove me crazy. Epoxy did the job for
me.
Andrew Uprichard
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Angelo Graham
Sent: Monday, January 21, 2013 4:44 PM
To: triumphs@autox.team.net
Subject: [TR] TR2/3 Badge fastening
Hello List:
Wondering what techniques listers have used to fasten the badges (&
letters) to the front clip and rear deck (TR2). I have used the pegs on the
backside of the badge and the "spring clips", but never really satisfied
with the fit. Also worried about how easy it would be to simply lift the
badge off the body.
Anyone use anything else? Almost tempted to use epoxy and worry about the
consequences later.
Thanks for any insights.
Angelo Graham
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/auprichard@uprichard.net
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|