It occurs to me that the nuts are designed to be self tightening..that's why
you don't hammer the c**p out of them. Over tightening actually damages the
cone in the wheel and on the hub, and can induce wobble.
Just a thought.
Sent from my Verizon Wireless Phone
----- Reply message -----
From: "Randall" <TR3driver at ca.rr.com>
To: <stag at digest.net>, "'Triumph List'" <triumphs at autox.team.net>
Subject: [TR] Knock off torque
Date: Sat, Jan 7, 2012 13:03
> I bought a tool that will allow me to use either a torque wrench or
> breaker bar for putting on and taking off my 2 eared knock
> offs. It's
> for my TR6 and Stag
How did your Stag wind up with 2-eared knock offs? They had "safety"
knockoffs originally (but otherwise the same size & thread as TR6).
> How can I find
> out a proper torque specification for putting on the nuts?
I doubt the factory ever published a spec, as they specifically said to use
a hammer. But one approach would be to install them with a hammer and then
measure how much torque it takes to remove them.
-- Randall
** triumphs at autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/spook01 at
comcast.net
|