> I bought a tool that will allow me to use either a torque wrench or
> breaker bar for putting on and taking off my 2 eared knock
> offs. It's
> for my TR6 and Stag
How did your Stag wind up with 2-eared knock offs? They had "safety"
knockoffs originally (but otherwise the same size & thread as TR6).
> How can I find
> out a proper torque specification for putting on the nuts?
I doubt the factory ever published a spec, as they specifically said to use
a hammer. But one approach would be to install them with a hammer and then
measure how much torque it takes to remove them.
-- Randall
|