> Regarding # 3 - Turn the engine over so that the ignition
> points are closed.
> Check for voltage between ground and the 12V terminal on the
> coil that is
> connected to the side of the distributor. There should be no
> voltage at that
> time.
While you're at it, also check for 12V between the other low tension coil
terminal (the one connected to the harness) and ground. Although not a
common problem, it is possible for a bad connection or contact to pass
enough current to read 12v with the points open, but not enough to power the
coil.
-- Randall
|